ELECTRIC HUB MOTOR SYSTEM … ROUND TWO
Anyone who has been following this blog knows I had a BionX hub motor system installed on my trike and that I experienced various problems with it that BionX never got resolved to my satisfaction. Consequently I requested a full refund and got it. Dispite the problems I experienced I really liked having the hub motor system on my trike and I really miss it now that I am without it. It has always been my intention to replace it with some other brand. I have spent a whole lot of hours researching to learn what is available in order to make a decision I am hopeful is the right one for me. I have listened to the counsel of others and considered the options.
I ruled out mid-drive systems as they just don’t appeal to me. If for no other reason I don’t like the idea of putting all the strain and wear and tear on my drive train. Also most mid-drive motors I have heard while watching videos of them were loud and I found that objectionable. I don’t like the idea of having a motor hanging on the end of my boom and I am not willing to give up two of my chain rings up front in order to have a motor placed there. I have 27 speeds and I want to keep them.
I like hub motors even though I know it makes dealing with a flat tire more complicated and difficult. But I usually run Schwalbe Marathon Plus tires and don’t get flats so that isn’t much of a concern. There are two basic types of hub motors … brushless gearless and brushless geared. As with most things there are pros and cons to both. After much studying I made the decision I wanted to stick with the brushless gearless type which is what BionX is. Hub motors with gears inside of them require replacing the gears periodically as they wear out. I didn’t want to get into that. Also brushless geared hub motors are usually noticeably louder that the brushless gearless type. I like my motor to be quiet. I mean … I may want to sneak up on somebody. 🙂 Seriously, I just like keeping a low profile. I would rather not draw attention to myself and my trike by having it produce noise others hear. Besides it is both annoying and embarrassing.
In my research I found that it is extremely easy to find hub motor kits for 26 inch wheels (and larger). However, finding them for 20 inch wheels is somewhat challenging. The lead mechanic at a local bike shop was also looking for a hub motor system for me and said the same thing. He found it difficult finding a hub motor kit for a 20 inch wheel. But with a lot of time and perseverence I did find a few. Within these “few” I had to select one and that can be difficult. I read all I could about the different ones. Only a few of the few had much of anything written about them so that narrowed it down some as I didn’t want to go into this blindly.
There are various sizes of motors available. My BionX was 350 watts. I have seen 250, 350, 400, 500, 600, 750, 1000, 1500, 2000, 3000, 5000, 10000, 15000 and even higher. I am sure riding a trike with a large motor would be exhilirating. However, I am pretty sure I would end up wrapped around some tree or worse. Besides the larger the motor the more battery power it requires and uses. The bottom line is one only needs enough power to do the job. My 350 watt BionX motor was pretty decent power-wise so 500 watts should be about perfect and sensible. BTW, here in the U.S. the legal limit for road use is 750 watts. In Canada is it 500 watts and in Europe it is only 250 watts. (I sure am glad I don’t live in Europe.) 250 watts is ridiculous. That won’t even climb many hills.
Most of the hub motors have the wires coming out of the end of the axle. That absolutely turns me off so I didn’t consider any of them. I don’t like the idea of their vunerabilty of getting damaged. So with this criteria the candidates were narrowed down considerably.
I am not going to name brands here for fear of offending someone who happens to have one of those brands. I may or may not have something against any of them. I am not here to put any other brands down or to advise others what I think they should buy. I am only concerned about what I think will be the best choice for me.
After a lot of deliberation i chose the Golden Motor Canada Magic Pie Edge hub motor. It is not the cheapest by far, but it is still reasonably priced. I bought my battery, charger and rear rack for the battery seperately as Golden Motors didn’t have what I was looking for. The total cost for the hub motor kit with the extra options I selected was $781.50. The battery, charger and rear rack was $560.49. Altogether it comes to about $1350. The BionX system I just had was nearly $2500 so you can see there is quite a difference is cost. As I said earlier the BionX was a 350 watt motor. This new one is 500 watts. The BionX battery was only 11.6 aH (the largest they offer). This new one is 20aH. I have seen as high as 50aH. I based my decision on this 20aH battery on what I experienced with the 350 watt motor and the 11.6aH battery. The range I got out of that combination was not very impressive … only about 35 miles on a good day. In colder weather it drops way off. The replacement cost of the BionX battery is over a thousand dollars. I can replace this battery for less than $400 (at least that is what I see currently looking at batteries). I would probably opt to spend more however and get a lithium-polymer battery next time instead of lithium-ion. They are still far less money than the BionX battery costs and are a much more powerful and higher quality battery than the BionX battery. I wanted to get a lithium-polymer battery at this time, but I also wanted to hold the cost down so I opted for the lithium-ion.
One thing I want to address here is the matter of the pedal assist mode and torque sensing being built into the circuitry inside of the hub motor. BionX does this. It is great until something happens to it like what happened to mine. My pedal assist feature stopped working. Fortunately it was under warranty so BionX replaced the hub motor. Unfortunately the motor they sent to replace it was the wrong motor … much less power than the one I had that went bad. This new motor I ordered does not have pedal assist or torque sensing built into the circuitry inside of the hub motor. It is a seperate external component which costs about $145 or so extra as it is optional. At first I was upset about this, but after thinking it over I changed my tune. If something were to happen to the torque sensing unit and it quit working it is a far easeir repair (for me) than BionX repair would be. Warranties don’t last all that long and then we are on our own. Repairs are out of pocket at that point. I don’t know what BionX charges for a new printed circuit board, but I would much rather replace the external torque sensor than have to open up the hub motor and replace the printed circuit board inside.
Lastly, this new motor has a few features BionX doesn’t have. It offers a reverse feature so one can use the motor to back up. It can be programmed offering three different selections of the rider’s choice as to how much power the motor is delivering. Typically one programs it to have a low power choice, a medium power choice and a high power choice. These can be selected as one is riding. By law here in the U.S. an e-bike (e-trike) can’t go any faster than 20 mph on roads when being powered by the motor. It seems so silly when there are riders who can obtain 40 mph or so thru pedaling. Many motors are capable of propelling the bike/trike faster than 20 mph, but by law they must be limited to a top speed of 20 mph. With this motor being programmable one could choose full power as one of the 3 available selections. That would propel the cycle much faster than the 20 mph top speed allowed. I tell you what … I won’t tell if you won’t. 😉 I am sure there are many who would choose to have full power available as one of the selections. It not only would provide the highest top speed obtainable, but it would provide maximum acceleration and performance. Anyone up for a drag race? Am I getting too old for that?
Well, that’s my story thus far. It is all on order. And yes, I am very anxious to get it and get it installed and working. And then I hope to …
KEEP ON TRIKIN’
I will keep readers updated. BTW, as stated, this is round two and hopefully it will be the final round.
Note – sadly it was not the last round. HERE you can read about round three.
A FREE GIFT awaits you!
Posted on January 30, 2018, in e-trikes, electric motorized trikes, pedal assist, tadpole trikes and tagged e trike, FREE GIFT, Golden Motors Canada, hub motors, Magic Pie Edge, motorzied tadpole trike, tadpole trikes. Bookmark the permalink. 11 Comments.